| Parameter: | Group: | Used in/Using parameters (direct dependence): | Where would the design resize when I change the parameter expression: |
| A | Main |
Used In: B (Main) TTW (Tuck Tongue) FH, FH1 (Flaps) |
Length of the box |
| B | Main |
Used In: PH, PH2, PH3 (Panels) VCO (Cut) Using: A (Main) |
Width of the box |
| H | Main | - | Height |
| GLC | Main | - | Correction because of the glue flap |
| UL | Main | - | Defines if layers should be used |
| LSC | Layers | - | Layer step crease |
| PH | Panels |
Using: B (Main) |
Panel Height |
| PH2 | Panels |
Using: B (Main) |
Panel height |
| PH3 | Panels |
Used In: VCO (Cut) FR (Panels) Using: B (Main) |
Panel height |
| DxT1 | Panels | - | Horizontal size of the taper |
| DyT1 | Panels | - | Vertical size of the taper |
| DxT2 | Panels | - | Horizontal size of the taper |
| DyT2 | Panels | - | Vertical size of the taper |
| TTW | Tuck Tongue |
Used In: TTB (Tuck Tongue) CL, ChordL (Cut) FH (Flaps) Using: A (Main) |
Tuck tongue width |
| TTH | Tuck Tongue |
Used In: DyTTT (Tuck Tongue) |
Tuck tongue height |
| DxTTT | Tuck Tongue |
Used In: ChordL (Cut) |
Horizontal size of the tuck tongue taper |
| DyTTT | Tuck Tongue |
Using: TTH (Tuck Tongue) |
Vertical size of tuck tongue taper |
| TTB | Tuck Tongue |
Using: TTW (Tuck Tongue) |
Tuck tongue bevel |
| CL | Cut |
Using: TTW (Tuck Tongue) |
Cut length |
| VCO | Cut |
Using: B (Main) PH3 (Panels) |
Vertical cut offset |
| ChordL | Cut |
Using: TTW, DxTTT (Tuck Tongue) |
- |
| ChordD | Cut | - | - |
| FH | Flaps |
Used In: FR (Panels) Using: A (Main) TTW (Tuck Tongue) |
Flap height |
| FH1 | Flaps |
Using: A (Main) |
Flap height |
| FR | Panels |
Using: PH3 (Panels) FH (Flaps) |
Fillet Radius |
| GL | Glue Flap | - | Glue flap width |
| GLA | Glue Flap | - | Webbed flap angle |
| GLA1 | Glue Flap | - | Glue flap angle |