| Name: | Description: | Used in/Using parameters: | Default expression (mm): |
| I90X | Defines the inside correction applied to the dividers, starting from opposite sides, when the folding is at 90 degrees and is parallel to the X axis. In contrast to C90X correction, this correction is not dependent on the dimension type (DT). |
Used In: X2, X3, X4 (Main) LSC (Barrier) PH4 (Panels) |
I90x(d(),fd()) |
| I90Y | Defines the inside correction when the folding is at 90 degrees and is parallel to the Y axis. It is relevant to bottom correction of the dust flap. In contrast to C90Y correction, this one is not dependent on the dimension type (DT). |
Used In: PH2 (Body) LSC (Barrier) |
I90y(d(),fd()) |
| O90Y | Defines the outside correction when the folding is at 90 degrees and is parallel to the Y axis. This correction is not dependent on the dimension type (DT), as well. | - | O90y(d(),fd()) |
| OHCDCX | - |
Used In: X3 (Main) PH4 (Panels) |
OHCDCx(d(), fd()) |
| OHCDCY | - |
Used In: PH2 (Body) |
OHCDCy(d(), fd()) |
| PHCX | - |
Used In: PH5 (Tray) |
PHCorrX(d(), fd()) |
| PHCY | - |
Used In: PH3 (Body) |
PHCorrY(d(), fd()) |
| O90X | - | - | O90x(d(),fd()) |